Parts

Parts Listing

Parts List for Rover V8 engines of various configurations

Due in main to the extremely wide variety of vehicles and applications of the Rover V8 engine, this page is designed to give some idea of the range of parts available and the cost of those parts. This is by no means a complete list of the parts we can supply, but rather an idea of the type of parts available. Should you have a specific requirement that is not listed here then please do not hesitate to contact us for information regarding your needs.

Gaskets

Rocker Cover

Cork - to fit all Rover V8 engines
£4 per pair
Rubber - to fit all models but standardly fitted to 4.0 and 4.6
£8 per pair

Inlet Manifold

Composite - to fit all engines
£9 each
Manifold gasket seals
£4 per pair

Heads

Standard 3.5 Ltr Tin (shim) gasket - 90mm
£12 per pair
Standard 3.5 Ltr Composite gasket - 90mm (lowers compression)
£22 per pair
Standard 3.9 Ltr Tin Gasket - 95mm
£17 per pair
Standard 3.9 Ltr Composite Gasket - 95mm
£22 per pair
Standard 4.6 Ltr Composite Gasket - 95mm
£30 per pair
Special 5.2 Litre Composite Gasket - 97mm
£34 per pair
Special 5.5 Litre Composite Gasket - 97mm
£34 per pair


Exhaust

Standard 4.6 Twin Steel
£7 per set of 4
V8 Developments Special Enlarged
£10 per set of 4

Cylinder Block

Sump Gasket (note - P38 RR and later do not require gasket)
£3 each
Front Crank Oil Seal
£4 each
Rear Main Cap Seal (crucifix seal)
£4 per pair
Crank Rear Oil Seal
£4 each
Side Bolt washers / seals
£15 set
Front cover gasket - pre-serpentine
£3
Front Cover Gasket - serpentine, GEMS, Thor
£4
Water Pump Gasket - pre-serpentine Range Rover
£2
Water Pump Gasket - pre-serpentine Rover SD1
£2
Water Pump Gasket - serpentine
£3

 

Ancillaries

Starter Motor - New - Gear Reduction (Range Rover, Other)
£90
Starter Motor - SD1 - Reconditioned (limited availability)
£90
Alternator - SD1 - Reconditioned
£85
Alternator - RRover P38 etc. - New
£150
Water Pump - SD1
£145
Water Pump - Serpentine
£55
Distributor - Late Type - Tongue drive - Amplifier attached
£275
Distributor - Mallory Electronic (requires coil)
£245
Sump - Baffled - Standard Height
£345
Sump - Baffled - Lowered (for added ground clearance) *** ASK
£395

 

Valve Train

Valve Springs - Standard Single
£35 set 16
Valve Springs - Single Uprated
£40 set 16
Valve Springs - Double
£58 set 16
Valve Springs - Special Order - Please ask
POA
Valve - Inlet - Standard
£24 set 8
Valve - Exhaust - Standard
£25 set 8
Valve - Inlet - 1. 63
£38 set 8
Valve - Exhaust - 1.40
£45 set 8
Valve - UBV Special Inlet - 1.70 - require large seats
£120 set 8
Valve - UBV Special Exhaust - 1.50 - require large seats
£120 set 8
Pushrod - Standard Hydraulic
£25 set 16
Pushrod - Adjustable Hydraulic
£90
Pushrod - Adjustable Solid Lifter
£120
Rocker Assemblies - Shafts, springs,arms - assembled
£195 per pair
Lifters - (camshaft Followers) - Hydraulic - Standard
£45 set 16
Lifters - Solid
POA

 

Induction

45mm aluminium Trumpet Base (Ram Stack)
£195 (exchange)
45mm Ported Inlet Manifold - Flapper/hotwire/GEMS
£195 (exchange)
72mm Plenum Chamber - Flapper/Hotwire/GEMS
£195 (exchange)
Smooth Bore Induction Hose - TVR Griffith/Chimaera - Plenum bend
£50
Smooth Bore Induction Hose - TVR Air Flow to Filter
£85
Air Flow Meter - Hotwire
£245
Westfield type Plenum Chamber
£525
Carbon Twin Plenum Chamber Kit - ACT Performance
£995
Carbon Tripple Plenum Chamber Kit - ACT Performance
£1345

 

Injection / Ignition

Fuel Injectors - Hotwire - Standard - Balanced Set
£160 (exchange)
Fuel Injectors - High Flow - 22lbs/hr
£250
Fuel Injectors - Very High Flow - 30lbs/hr
£295
EFi Fuel Pump
£85
Throttle Potentiometer - Hotwire
£75
Throttle Potentiometer - Throttle Bodies - DTA , OMEX
£85
Tornado ECU Chip
£325
Down Draught Throttle Bodies and Manifold Kit
£2,500
OMEX 710 ECU & Wiring Loom
£1,500
Complete Aftermarket Injection and Ignition System - OMEX or DTA, DownDraught Injection Linkages and Fuel rails - please ask for details
£4,500

 

 

Home | Products | Contact Us | ©2006 V8Developments Ltd.